| Technical
data and performance for the
Olionik HiFi amplifier type
Olionik 1. General
technical information.
* The Olionik
amplifier is a special designed
amplifier based on vakuumtube.
* The output stage
is based on a Russian type of
vakuumtube called 6C33. Its a
special military type of triode
based for rough environmental
conditions.
* The output stage
is based on 4 of these triodes.
* Totally there is
13 different types of vakuum
tubes in the construction.
* The amplifier has
two different meters that can
measure the following items:
* The anod current
to the triodes
* The glowing
current to the triodes.
* The output power
of each channel.
* The anod current
is not connected to the triod
until the triod has reach enough
heating.
* The amplifier has
a build in time meter that gives
the information of the total used
time for the amplifier.
Signal input.
* The amplifier has
two separate channels.
* The amplifier can
be driven either with a common
input for both channels or by
separate input for each channel.
* The input
impedance with common input is
0,5 kohm.
* The input
impedance with separate channels
is 1,0 kohm.
* Input voltage
level on common input is 0,66
Volt peak to peak.
* Input voltage
level on separate input is 0,66
Volt peak to peak.
* Connectors for
input is a type phono JCR type.
Signal
quality.
* The harmonically
distortion is better than 0.05%
at 1000 Hz.
* The
intermodulation distortion is
less than 0.1% at a carrier
frequency of 100 kHz and a
modulation of 100 Hz.
* Bandwidth 35 (-3
dB) to 35 000Hz (-3dB).
* The amplification
is 40 dB for the common input at
a feedback level of 20 dB.
* The amplification
is 60 dB for the separate input
with a feedback level of 20 dB.
Signal output.
* The amplifier is
optimized for 8 ohm load.
* The output stage
is special designed based on a
Russian type of triode called
6C33C
* The output
connectors for the amplifier are
placed on the back side and is a lab connector with
a diameter of 4 m.m.
* The maximum output
with a 8 ohm load is 50 Watt for
each channel.
Electrical
power input.
Input voltage 220
volt rms. +_10%.
Input current 2 amp.
Fuse 2 amp. The fuse
is placed in above the power
input to the amplifier.
Mechanical
data.
Dimension
540*360*120 m.m.
Weight 10 kg.
Miscelangelous.
The color of the
amplifier is black with corner of
gold.
On the top of the
amplifier the final stage is
protected by special designed
mechanical parts.
Each amplifier has a
special serialnumber. Each
amplifier are handmade and each
type will only be manufactured in
a limited number of
units.
|
